Published at Friday, 14 September 2018. Stair. By Alwine Seiler.
If you do not have enough money to buy stair lifts, do not worry as you can always opt for stair lift rental. People do not need to stay confined at one place if the two legs given to them are working properly. But sometimes it so happens that due to some reason or the other the ability to walk is lost. You cannot move about freely and you cannot even go up and down the stairs as and when you require. Losing the ability to walk is really painful. Most of the time, one needs to remain confined at one place. You might break your leg or have some pain in your leg. The legs might even be paralyzed or there might be illness like arthritis which forces a person to stop the movement of the legs. At that point of time going up and coming down the stairs becomes a serious problem.
Starting with two parallel 2x6 stringer members, the adjustable brackets are first positioned using a spacing tool and then attached to each member with a single "pivot screw". For finished interior stairs, the stringers may be "paint" grade or "stain" grade but will have a tongue and grove or spline milled into the parallel mating surfaces so that once the brackets are adjusted, the mating surfaces will be pushed together to form a continuous, decorative, one piece knee wall stringer. The remaining screws are inserted and the end cuts are made. All the risers and treads are now square cut to the exact length using a chop saw. It is recommended that a stop is used for accuracy and efficiency. The treads are usually cut slightly shorter than the risers (1/64") for fit. For fast assembly it’s best to first pre- assemble the stair and then lift into position whenever circumstances permit.
The first stringer can be laid on the floor using blocks and one end of each riser is attached to each bracket so that the risers are in a vertical position in relation to the stringer. The risers are attached to each bracket using blind screws through the holes in the brackets. The second stringer is then positioned over the opposite ends of the risers and attached. A clamp may be used to pull the stringers tight against the riser ends. This one step will eliminate up to 80% of the custom fitting normally required for conventional stairs.
Any content, trademark’s, or other material that might be found on the heartlandanimalhospital.us website that is not heartlandanimalhospital.us’s property remains the copyright of its respective owner/s. In no way does heartlandanimalhospital.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 heartlandanimalhospital.us. All Rights Reserved.