Published at Friday, 14 September 2018. Stair. By Christina Finke.
Starting with two parallel 2x6 stringer members, the adjustable brackets are first positioned using a spacing tool and then attached to each member with a single "pivot screw". For finished interior stairs, the stringers may be "paint" grade or "stain" grade but will have a tongue and grove or spline milled into the parallel mating surfaces so that once the brackets are adjusted, the mating surfaces will be pushed together to form a continuous, decorative, one piece knee wall stringer. The remaining screws are inserted and the end cuts are made. All the risers and treads are now square cut to the exact length using a chop saw. It is recommended that a stop is used for accuracy and efficiency. The treads are usually cut slightly shorter than the risers (1/64") for fit. For fast assembly it’s best to first pre- assemble the stair and then lift into position whenever circumstances permit.
A stair lift is not only something that has a lot of significance for the concerned people, but is also a major investment. This is the reason that makes it important that a stair lift has to be just right and adequate to the needs as well as safe. If you are the one for quality, then two manufacturers are there who are famous for their best quality. One is Stannah and the other is Bruno. Stannah is a UK manufacturer while the latter is a US manufacturer of stair lifts. The manufacturers and models for the straight and curved stair-lifts differ and there are different companies that have established a great name in their respective kinds of stair lifts. For the curved stair lift, ThyssenKrupp Access and Bruno manufacture the most popular and top quality models. ThyssenKrupp Access offers the model Stair Glide and Flow II in curved stair lifts and Bruno makes the curved stair lift, which is the Electra-Ride III.
The stair is now laid on its back and (starting from the bottom step) the treads are laid in position, fitting perfectly without gaps. As each tread is positioned it is attached to the rear riser. Once all treads are positioned, the stair is laid on its side again and the end screws through the brackets are inserted. The fasteners attaching the tread to the top of the rise may be inserted as blind screws (using pocket holes in the risers) or blocks from the underside or simply using finished nails from the top.
Any content, trademark’s, or other material that might be found on the heartlandanimalhospital.us website that is not heartlandanimalhospital.us’s property remains the copyright of its respective owner/s. In no way does heartlandanimalhospital.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 heartlandanimalhospital.us. All Rights Reserved.