Published at Friday, 14 September 2018. Stair. By Elise Luthi.
Starting with two parallel 2x6 stringer members, the adjustable brackets are first positioned using a spacing tool and then attached to each member with a single "pivot screw". For finished interior stairs, the stringers may be "paint" grade or "stain" grade but will have a tongue and grove or spline milled into the parallel mating surfaces so that once the brackets are adjusted, the mating surfaces will be pushed together to form a continuous, decorative, one piece knee wall stringer. The remaining screws are inserted and the end cuts are made. All the risers and treads are now square cut to the exact length using a chop saw. It is recommended that a stop is used for accuracy and efficiency. The treads are usually cut slightly shorter than the risers (1/64") for fit. For fast assembly it’s best to first pre- assemble the stair and then lift into position whenever circumstances permit.
The first stringer can be laid on the floor using blocks and one end of each riser is attached to each bracket so that the risers are in a vertical position in relation to the stringer. The risers are attached to each bracket using blind screws through the holes in the brackets. The second stringer is then positioned over the opposite ends of the risers and attached. A clamp may be used to pull the stringers tight against the riser ends. This one step will eliminate up to 80% of the custom fitting normally required for conventional stairs.
The biggest danger with AC powered stair lifts is that during a power failure, the stair lift will not function. Early versions of stair lifts were all AC powered. Trailing electrical cables presented tripping hazards, and the lifts moved in a jerky, start-stop manner due to the nature of the AC powered motor. At that time there wasn’t much choice because battery technology had not advanced as far as it has today. Today, DC powered stair lifts that only recharge from the household supply of electricity are the most popular lift chair designs. With DC powered stair lifts, if the power goes out, the battery can’t charge, but the lift will still be functional until the battery’s charge runs out. These models are quieter than AC models, too.
Any content, trademark’s, or other material that might be found on the heartlandanimalhospital.us website that is not heartlandanimalhospital.us’s property remains the copyright of its respective owner/s. In no way does heartlandanimalhospital.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 heartlandanimalhospital.us. All Rights Reserved.